Sleep Mode

Материал из SmartPlayer
Это перевод страницы Режим "Засыпания", он готов на 100%.

Description of the Situation

The information on this page is dedicated to the operation of the sleep mode on devices when working with schedules on the SmartPlayer platform.

This functionality is only supported on devices running Android OS. In the future, it is planned to expand the number of supported devices and operating systems.

Action Algorithm

First, the user must register or log into their SmartPlayer account.
The next step is to navigate to the "Devices" section.

Example of the "Devices" section display in the personal account

In the "Devices" section, the user needs to select the desired device and click on it. This will highlight the device.

Example of selecting a device in the personal account

After selecting the device, the page display will change, and a toolbar with device settings will appear on the right-hand side. The user should move to the toolbar and select the "Settings" line.

Example of the "Settings" line display in the toolbar

By opening the "Settings" page, the user should select the first line named "Automation Management."

Example of the "Automation Management" settings block display

After completing the steps described earlier, a new window will appear where the user needs to find the "General" section. In this section, there are timers for turning the device on and off, below which is the checkbox labeled "Use Sleep Mode."

Example of the "Use Sleep Mode" checkbox display

Activating this checkbox will enable the sleep mode on devices.

To complete the device settings, the user needs to scroll down to the end of the page and click the "Save Changes" button.
Example of the "Save Changes" button display

Difference Between Old and New Implementations

The above information about sleep mode describes a new implementation of the functionality. The principle of operation for putting the device into sleep mode has been completely revised.

Sleep Mode Implementations
Old New
The old implementation used hibernation mode with a black "mask" while the display backlight remained active, increasing energy consumption. System checks occurred every 10 minutes. Information about volume and brightness settings was not saved when entering sleep mode. The new implementation puts the device into full sleep mode, closing the video channel with the server. Using a checkbox activates sleep mode, which previously could only be enabled manually through the personal account. Before turning off, the device saves brightness and volume settings to ensure correct operation upon activation. The device status in sleep mode changes from a green frame to a blue one.

Video Guide

Sleep Mode on Devices

Additional Information

If this article does not help to use the functionality as intended, or if there are any questions after reading it, you can voice these questions in the "Discussions" section at the top of the page.

Example of the "Discussions" tab display on the wiki page

Additional information can also be found on the page Как взаимодействовать пользователю с разделом "Обсуждения".