Translations:IPTV/5/en

Материал из SmartPlayer
Версия от 15:36, 28 марта 2024; FuzzyBot (обсуждение | вклад) (FuzzyBot переименовал страницу Translations:Раздел IP - телевидение (IPTV)/5/en в Translations:IPTV/5/en без оставления перенаправления: Часть переводимой страницы Раздел IP - телевидение (IPTV).)
(разн.) ← Предыдущая версия | Текущая версия (разн.) | Следующая версия → (разн.)

IPTV Operation on Android OS

During IPTV tests on Android OS, a remote control from a Ugoos set-top box was used.

After enabling and configuring IPTV in the personal account, the user can press and hold the central "OK" button on the remote for 5 seconds to launch IPTV mode.
If the user has configured channels (as described earlier in the article about IPTV settings in the personal account), then IPTV will start operating normally. If the channels were not added, switching to IPTV mode will result in a black screen.
IPTV on Android OS can operate with the following stream types:

  • HLS
  • SmoothStream
  • DASH
  • UDP
  • HTTP
"RTP" and "RTSP" streams were not tested with IPTV operation.

The following buttons are used for operating IPTV on the device:

  • The "OK" button/single press of the "Up" button/single press of the "Down" button - opens the side menu with channels. The side menu will close after five seconds of inactivity.
  • A single press of the "Left" button/single press of the "Right" button - opens the channel categories catalog. This menu will close after fifteen seconds of inactivity.
  • The "Back" button - closes the above menus/takes a step back. This button also allows turning off IPTV mode when pressed during channel playback.

Subtleties and Nuances When Operating on Android OS

  • When adding a YouTube stream as a channel, use the link from the address bar, not the "Share" button in the YouTube menu.
  • In the channel switching menu, when moving to the next channel (highlighting it without switching), the system will automatically switch to the highlighted channel after one second.
  • An error may appear in the center of the screen during channel operation, and the channel playback may stop. In this case, the user needs to switch to another channel.