Translations:Инструкция для настройки виджета навигации (ver. 2.0)/5/en

The "Add Terminal" Button

After clicking the Add Terminal button, the user will be taken to the terminal settings section, which will appear on the panel after the interface changes.

Example of the settings panel after clicking the Add Terminal button

The terminal settings include the following parameters:

• Name — allows the user to specify the name of the new terminal;
• X Position — this field cannot be entered manually. The value is determined automatically after the user clicks the desired location on the map with the left mouse button;
• Y Position — this field cannot be entered manually. The value is determined automatically after the user clicks the desired location on the map with the left mouse button.

Example of the completed settings for a new terminal

After completing the terminal configuration, the user must click the Apply button on the right panel. If the changes are not satisfactory, the user can click the Cancel button located to the left.

Example of the Apply and Cancel buttons

After completing the configuration, the user will see the new terminal in the list. Added terminals can be edited or deleted using the dedicated icons available on this panel.

Example of configured terminals and the icons used to interact with them

The "Add Elevator" Button

After clicking the Add Elevator button, the user will be taken to the elevator settings section for the map, which will appear on the panel after the interface changes.

Example of the settings panel after clicking the Add Elevator button

The elevator settings include the following parameters:

• Name — allows the user to specify the name of the new elevator;
• X Position — this field cannot be entered manually. The value is determined automatically after the user clicks the desired location on the map with the left mouse button;
• Y Position — this field cannot be entered manually. The value is determined automatically after the user clicks the desired location on the map with the left mouse button;
• Elevator Enabled checkbox — enables or disables the use of the elevator during route calculation. If this parameter is enabled for elevators on both the starting and destination floors, the route will be built using elevator navigation.

Example of an elevator displayed on the map

After completing the elevator configuration, the user must click the Apply button on the right panel. If the changes to the elevator position are not satisfactory, the user can click the Cancel button located to the left.

Example of the Apply and Cancel buttons

After completing the configuration, the user will see the added elevators in the list. Elevators in the list can be edited or deleted using the dedicated icons available on this panel.

Example of configured elevators and the icons used to interact with them

The "Add Staircase" Button

After clicking the Add Staircase button, the user will be taken to the staircase settings section for the map, which will appear on the panel after the interface changes.

Example of the settings panel after clicking the Add Staircase button

The staircase settings include the following parameters:

• Name — allows the user to specify the name of the new staircase;
• X Position — this field cannot be entered manually. The value is determined automatically after the user clicks the desired location on the map with the left mouse button;
• Y Position — this field cannot be entered manually. The value is determined automatically after the user clicks the desired location on the map with the left mouse button;
• Staircase Enabled checkbox — enables or disables the use of the staircase during route calculation. If this parameter is enabled for staircases on both the starting and destination floors, the route will be built using stair navigation.

Example of a staircase displayed on the map

After completing the staircase configuration, the user must click the Apply button on the right panel. If the changes to the staircase position are not satisfactory, the user can click the Cancel button located to the left.

Example of the Apply and Cancel buttons

After completing the configuration, the user will see the added staircases in the list. Added staircases can be edited or deleted using the dedicated icons.

Example of configured staircases and the icons used to interact with them